Attachments for a Kubota K008-3
A Kubota K008-3 is a 2,200 lb (1 t) mini excavator, which puts it in the 1–2 t compact class. It takes 25 mm bucket pins on a pin-on stick. 2 attachments in the Quarrymark range fit a Kubota K008-3: 1 post driver hammer and 1 quick coupler. None is graded a direct fit yet, but 2 need a mounting detail confirmed before they ship. Prices start at $831.20.
Kubota K008-3
| Operating weight | 2,200 lb · 1 t |
|---|---|
| Weight class | 1–2 t · compact |
| Bucket pin diameter | 25 mm |
| Coupler / interface | Pin-on |
| Machine type | Mini Excavator |
| Attachments that fit | 2 (0 direct fit) |
Operating weight is from the manufacturer’s published spec sheet. Pin diameter and coupler style are derived from that weight against our own tonnage bands. They are the right starting point for a machine in this class, not a statement about your specific unit. Verify both against your OEM spec, or send us a photo of the stick end and we will confirm it before you order.
2 attachments for a K008-3
We grade the fit rather than answer yes or no. Direct fit means the weight class and the mounting both check out. Fits your class means the attachment is rated for a machine of this weight and mounts pin-on. Verify first means something, usually the pin diameter, needs confirming before it ships. Telling a contractor a bucket fits when it does not is how you earn a freight claim.
Everything that fits a Kubota K008-3
Post Driver Hammers for a K008-3
1 post driver hammer
Buying attachments for a Kubota K008-3
What size bucket fits a Kubota K008-3?
We do not currently list a width-sized bucket rated for a Kubota K008-3 at 1 t. Call (704) 555-0140 with the machine's operating weight and stick-end dimensions and we will size one from the class either side of it.
What pin size does a Kubota K008-3 use?
A Kubota K008-3 in the 1 t class typically runs 25 mm bucket pins on a pin-on connection. That is the number to check first, because it is the one that stops a bucket going on: the weight class tells you whether the machine can lift the attachment, the pin diameter tells you whether it will physically pin up. 2 of the 2 attachments listed here are the right weight class but drilled for a different pin. They are flagged "check pin size", and a bushing kit or a quick coupler resolves them. Pin diameter is derived from the machine's operating weight against our own tonnage bands, so measure yours or send us a photo of the stick end before ordering.
Can I run a hydraulic hammer on a Kubota K008-3?
Yes. 1 of our hammers are rated for a machine this size. They run 350 joules of impact energy, which is the range a 1 t carrier can actually feed. The constraint is hydraulic, not structural: the machine needs an auxiliary circuit with the flow and relief pressure the hammer is specified for, and a machine plumbed only for a thumb will not run a breaker without the second circuit. Check your auxiliary flow on the machine's spec plate, or send it to us and we will match the hammer to it.
Will a quick coupler fit a Kubota K008-3?
Yes. 1 coupler in our range is rated for a machine at 1 t. A coupler is the single best purchase on a 1 t machine that changes attachments more than once a day: it turns a twenty-minute pin-and-hammer job into a thirty-second swap from the seat, and it decouples you from the 25 mm pin diameter so you can buy attachments on price and spec instead of on drilling. Free freight applies over $750.
